SharkBite Fittings
SharkBite
Cut. Push. Done! SharkBite Push-Fit brass fittings take all the work out of a plumbing job! No solder, no glue, no wrenches, no mess. Just cut the pipe or tubing square and remove any debris or rough edges before pushing into the fitting. These fittings connect copper, CPVC and PEX tubing, wet or dry, in any combination. Fittings can be rotated after assembly for easier installation in tight spaces. SharkBite fittings can be removed and reused.
SharkBite fittings are approved for potable (drinking) water and hydronic (hot water) heating systems. They are certified for underground, under floor and behind finished walls. Rated for 200 psi and 200 degrees F (93 C).
0.00
SharkBite couplings
This brass fitting joins two pieces of the same size copper, PEX or CPVC pipe
read more ▼
0.00
SharkBite reducer couplings
This brass fitting joins two pieces of different size copper, PEX or CPVC pipe
read more ▼
0.00
SharkBite male adapters
This brass fitting connects to copper, PEX or CPVC on one end and has a male pipe thread (mipt) on the other end
read more ▼
0.00
SharkBite female adapters
This brass fitting connects to copper, PEX or CPVC on one end and has a female pipe thread (fipt) on the other end
read more ▼
0.00
SharkBite 90 degree ells
This brass fitting joins two pieces of the same size copper, PEX or CPVC pipe to form a 90 degree ell
read more ▼
0.00
SharkBite tees
This brass fitting joins three pieces of the same size copper, PEX or CPVC pipe to form a tee
read more ▼
0.00
SharkBite caps
This brass fitting caps off copper, PEX or CPVC plumbing lines. Use them to temporarily cap a pipe while you do a repair job or to permanently seal an unused line.
read more ▼
9.64
SharkBite U334LF 1/2" SB x 1/2 female lug ell, lead freeSKU 18-273$9.649.64
Sharkbite U334LF 1/2 SharkBite x 1/2 female 90 degree lug ell, lead free
read more ▼
0.00
SharkBite ball valves
These brass ball valves for copper, PEX or CPVC are full port and rated 200 psi
read more ▼
16.02
SharkBite 23037-0000LF 1/2 chrome straight stop, lead freeSKU 18-330$16.0216.02
SharkBite 23036-0000LF chrome plated brass straight stop valve, 1/2" SharkBite x 3/8OD compression, lead free
read more ▼
16.79
SharkBite 23036-0000LF 1/2 chrome angle stop, lead freeSKU 18-335$16.7916.79
SharkBite 23036-0000LF chrome angle stop valve, 1/2" SharkBite x 3/8OD compression, lead free
read more ▼
16.13
SharkBite 23337-0000LF 1/4 OD chrome straight stopSKU 18-339$16.1316.13
SharkBite 23337-0000 chrome straight stop valve, 1/2" SharkBite x 1/4 OD compression, lead free, often used for ice maker installations
read more ▼
0.00
SharkBite disconnect clip
This plastic clip is used to easily remove previously installed SharkBite fittings and valves. SharkBite fittings can be reused multiple times.
read more ▼
15.85
SharkBite U702 Safe Seal ToolSKU 18-385$15.8515.85
with deburring and depth gauge for 1/2, 3/4 and 1" SharkBite fittings
read more ▼
26.56
3/4 x 18" flexible s.s. connector, FIP x SharkBite, lead freeSKU 41-28B$26.5626.56
3/4 FIP X 3/4 SharkBite U3088FLEX18LF 18" flexible stainless steel water heater connector, attaches water heater to 3/4 copper, CPVC or PEX tubing, lead free
read more ▼
26.93
3/4 x 1/2 x 18" flex stainless steel connector, 3/4 FIP x 1/2 SharkBite, lead freeSKU 41-28C$26.9326.93
3/4 FIP X 1/2 SharkBite U3068FLEX18LF 18" flexible stainless steel water heater connector, attaches water heater to 1/2 copper, CPVC or PEX tubing, lead free
read more ▼